The LBA-C-100 is a beam analyzer for high power lasers, in particular for laser show projectors.

The LBA-C-100 analyzes the laser beam to enable to measure the main specifications that qualify the quality of the beam.
The angular measurement method used by the LBA-C-100 gives the advantage to not depend on the input beam diameter or on the distance bewteen the measuring device and the laser source. The resolution on the measure is 0.01mrad.
The LBA-C-100 is well suited for the measurement of the following specifications:

• » Divergence of the laser beam for each colour and for all colours simultaneously.
• » Laser power measurement
• » Lens collimating of laser sources : minimal divergence
• » Alignment of RGB laser beams

Optical specifications

Parameter	Symbol	Min	Typ	Max	Unit
Optical power (*)(**)	Popt	0.1	-	100	W
Power measurement accuracy		-	1	-	%
Resolution on divergence	RΦ	-	0.01	-	mrad
Divergence measured (FWHM)	Φ	0.1	-	10	mrad
Input beam diameter	D	-	-	22	mm
Wavelength detected	λ	400	-	1000	nm

Mechanical specifications

Parameter	Symbol	Value	Unit
Length x Width x Height (without the support / handle)	L x W x H	100 x 75 x 57	mm
Weight	msys	500	g

Electrical specifications

Parameter	Symbol	Value	Unit
Typical consumption (USB 3.0)	PUSB	2	W

(*) The sensor of the LBA-C must remain below 75°C while operating. It may be need to dissipate heat from the case with a fan when using the device with high power beams for a long period.
(**) A correct alignment should be done before setting the laser projector to maximum power. The user must follow the alignment procedure described in the User Manual to prevent damage to the system.

» Download the Datasheet